Have you ever spent hours machining a stock part…only to find the condition of supply was poor to begin with? This can be a frustrating nightmare, especially if you’re working with castings, composites, or additive parts.
By the time you’re measuring parts on a CMM, it’s too late. The time, material and cost has already been wasted — but how were you supposed to know that the stock material might not have been there or was too distorted to begin with?
That’s where NC-PartLocator from MSP PerfectPart comes in. Most measuring systems only measure the finished part using the CAD model. NC-PartLocator is different – it measures the stock material using metrology and 5-axis probing and checks there is a good part in there before you start machining. A much smarter way of working.
You get a detailed, traceable report so if the stock’s not right, you can reject it — and send it back to your supplier before it’s too late. Plus, the software tracks consistency over time — so if quality starts to slip, you’ll be alerted.
Don’t let bad stock waste good production time and resources.
Let MSP PerfectPart help you, get in touch using the form below.
